Table of Contents
Advertisement
Care and Maintenance (Continue)
Care and Maintenance of the Tap water supply.
If the tap water supply time becomes too long or [C01] appears on the display, please take care of it.
To prevent water splashing, please follow these steps:
1
Close the tap.
2
Drain the water in the water supply hose.
Press
S elect the "Rapid 15" program.
※
This is because the water supply operation starts immediately.
Press
The residual water in the water supply hose enters the drum.
Press
Press
3
Turn the union nut in the direction of the arrow and disconnect the water
supply hose.
Residual water in the water supply hose may drip. Place a container such as a bucket at the
end of the water supply hose, or use a cloth to catch the water.
4
Remove any debris from the water inlet filter with a toothbrush.
Remove the water inlet filter with pliers and clean it. Do not forget to put the filter back in place
after cleaning. Failure to install it may cause the water supply valve to malfunction.
5
Attach the water supply hose to the water inlet.
Tighten the union nut securely. If it is loose, it may cause water leakage.
6
Open the tap.
50
to turn on the power.
and let it run for about 10 seconds.
to pause operation.
to turn off the power.
Water inlet filter
Pliers
Close
Union nut
Water inlet filter
Open
Toothbrush
Hide quick links:
Advertisement
Table of Contents
