Table of Contents
Advertisement
Programming Professional Series Radios for use with a Basic Repeater Controller
Bi-directional Repeater
NOTE
Programming for Carrier Squelch opera-
tion will allow proper monitoring of the
operating frequency if required by local
communications regulations.
22. Enter the transmit frequency for the receive
radio of the bi-directional repeater in the "Tx"
area at "Frequency (MHz)".
23. Select the transmitter "Squelch Type:" based
upon the type of operation that is required
(CSQ, TPL or DPL). Your screen should
appear similar to Figure 8-11.
Figure 8-11. Conventional Personality, Basic,
Receive Radio
24. Enter any other special programming require-
ments in the appropriate windows.
25. Assign the personality to a zone in the "Per-
sonality Assignment to Zone" selection win-
dows.
26. Program the receive radio.
Transmit Radio Programming
1.
Read the Professional Series transmit radio.
2.
After the radio is read, select "Radio Configu-
ration" from the opening CPS "Tree View"
window.
3.
Click the "Basic" tab.
4.
If necessary, un-check the "Hook (HUB)
Defeats PL" selection box. Your screen should
8-6
appear similar to Figure 8-1 on page 8-1 for
the receive radio.
5. Click the "Accessory Configuration" tab.
6. Click the "Rx Audio Type:" dropdown arrow
button. Select "Filtered Audio".
7. Click the "Ext. PTT Audio" dropdown arrow
button. Select "Ext Mic Audio".
8. Click the "Ignition Sense Type:" dropdown
arrow button. Select "On/Off & Ignition".
Your
screen
Figure 8-5 on page 8-3.
9. Click the "Accessory Pins" tab.
10. Click the "Accessory Package" dropdown
arrow button. Select "RICK or I20R Tx". Verify
that pin 3 is "External Mic PTT (Input)",
Active Level "Low".
11. Click on the "Pin #8" down button. Select "PL
and CSQ Detect/Talkgroup Detect (Output)",
Active Level "Low". Your screen should
appear similar to Figure 8-12.
Figure 8-12. Basic (R*I*C*K) Bi-directional
Repeater, Accessory Pins, Transmit Radio
In order to realize a "transparent" operation (60% peak
system deviation from the transmit radio for 60% peak
system deviation on the received signal), the accessory
microphone gain for the transmit radio may be
increased.
12. Click on the "Microphone" tab.
6864110R66-O
CDR500 & CDR700 Repeater Service Manual
should
appear
similar
to
March, 2001
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
