Table of Contents
Advertisement
4. Using a commercially available strap wrench (D),
hold the flywheel and remove the flywheel retaining
bolt (E).
5. Fully install Flywheel Puller (PA-49316) on the
threads of the flywheel (left hand thread - turn
flywheel puller counterclockwise to install).
6. Hold puller body and tighten the center bolt to
remove the flywheel.
Starter One-Way Clutch Inspection
NOTICE
The starter one-way clutch can be serviced with the
engine installed in the chassis.
7. Remove the stator cover and flywheel. Refer to
"Stator Cover Removal / Inspection"page 3.45
and "Flywheel Removal"page 3.46 procedures.
8. Place flywheel on a work bench with the one-way
clutch facing up. Grasp clutch gear and rotate
clockwise. It should turn smoothly without binding.
9. Rotate one-way gear counterclockwise. The gear
should immediately lock in position and not slip.
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
ENGINE / COOLING / HVAC SYSTEM
10. Inspect the one-way gear bushing (A) for wear or
galling. If service is required, refer to "Starter One-
Way Clutch Disassembly"page 3.47 procedure.
STARTER ONE-WAY CLUTCH DISASSEMBLY
1. Lift up to remove starter one-way gear.
2. Remove the three one-way clutch retaining screws.
3
3.47
Advertisement
Chapters
Table of Contents
Troubleshooting
