D-Link DIR-822 User Manual page 108
Ac1200 wi-fi router
Hide thumbs
Also See for DIR-822:
- User manual (235 pages) ,
- Quick installation manual (54 pages) ,
- Quick instillation manual (35 pages)
Table of Contents
Advertisement
Section 4 - Configuration
Toggle this switch to enable Dynamic IPsec.
Enable:
General Settings
Choose IP version.
IP version:
Enable or disable dynamic IPsec.
Dynamic IPsec:
Choose type of address.
Type:
Enter IP address of remote host. If Dynamic IPsec is enabled, this field
Remote Host:
will be disabled.
Specify from the drop down list either IP address or fqdn as local
Identifier value:
identifier
Specify a pre-shared key.
Pre-shared key:
Specify from drop down list either Default gateway or Interface.
Local WAN:
Specify from drop down list Disabled or Enabled.
NAT Traversal:
Specify from down list TUNNEL or TRANSPORT.
Type:
Toggle this switch to enable/disable Dead Peer Detection.
Enable DPD:
Specify in seconds DPD delay.
DPD delay:
Specify maximum seconds of DPD timeouts.
DPD time out, sec:
Specify from drop down list either Manual or Path MTU Discovery.
TCP MSS:
D-Link DIR-822 User Manual
IPsec/Adding
104
- Quick Links:
- Router Mode
- Repeater Mode
Hide quick links:
Advertisement
Table of Contents
