Table of Contents
Advertisement
Installation steps
The following installation steps apply to left-open doors. For right-open doors,
please read the chapter [Pre-installation instructions] carefully and make
needed adjustments.
Use the drilling
1
template to drill
the needed holes
on the door and
mount the mortise
into the door.
Pass the cable through the hole
4
on the door. The square shaft
needs to be inserted into the
rotary hole on the mortise, so that
the outer escutcheon stays close
to the outside door.
Tighten the 4
2
anchor screws
on the mortise.
Attention
Please make sure
the main dead bolt
is retracted during
installation.
5
Install the connecting
3
screw tubes on the
outside escutcheon. Place
the square shaft and
compressed spring into
the hole of the handle.
M6 screw tube
Attention
Select a square shaft and connecting
screw tube with appropriate length.
Tighten the mounting plate
with the 4 M5 chamfer
head screws against the
inside of the door.
35mm square shaft
Compressed Spring
M5 screw tube
7
Advertisement
Table of Contents
