Table of Contents
Advertisement
See Appendix F for a drawing of the stand with the product mounted.
7.2.1 Mounting the product to the stand
The product must be installed on an appropriate mounting structure, such as the
optional but recommended mounting stand as shown in Figure 7-3.
The product weighs up to 30.5 kg (68 lb) so it is important to take precautions
prior to lifting. The product shall be lifted into position using sufficient
personnel or mechanical means in accordance with local regulations and
company policies.
Figure 7-3: The product mounted on a stand
The following steps are recommended for mounting the product to the mounting stand
(if purchased):
▪
Have all hardware needed to join the two parts of the stand ready and within reach
(the supplied M8 60 mm bolts).
▪
Ensure the bottom mounting stand is secured to the mounting surface in the desired
position using appropriate hardware, and within 5 degrees of level and plumb.
▪
To secure the product to the top stand (if not already pre-attached), lift the product
and position the four mounting tabs found on its back corners onto the studs
protruding from the top stand. Then use the nuts and washers included with the
mounting stand and tighten them sufficiently to the studs.
▪
Lift the product (attached to the top stand) while additional personnel help position it
over the now secured bottom mounting stand, such that the bolt holes on both the
top and bottom stands are aligned.
The product must be lifted by the main enclosure casing or top stand — not by
the door or fan etc., as this could damage the product.
▪
Then attach using the supplied bolts, nuts and washers, and secure sufficiently such
that the complete assembly is level and stable.
Alternatively, for new products (not previously commissioned) it is acceptable to
carefully lay the bottom mounting stand on its back and join the product to it while on
MA-005 - Minitrans Installation Manual - Rev 4.5
13-Aug-20
Page 17 of 86
Advertisement
Table of Contents
