3.1
Commissioning of the system - "Smart Access Point Pro"
3.1.1
Overview
Commissioning of the "Smart Access Point Pro" system is carried out in 3 sections.
–
Please observe the order of the steps. They are dependent on each other.
1.
Connect the "Smart Access Point Pro" via WLAN with
a computer any call up the website of the "Smart
Access Point Pro".
2.
Make a preliminary decision about the system mode.
3.
Run through the wizard with selection of the system
mode.
3.1.2
Connecting a PC with the "Smart Access Point "
Attention! Loss of data
The "Smart Access Point" safely integrates the device found into the system with
the aid of certificates. This makes encrypted communication between all devices
possible.
■
Connecting the "Smart Access Point" with the PC via WLAN
P E
o
Fig. 19:
Connecting the "Smart Access Point" with the PC (Access-Point mode)
As soon as the "Smart Access Point" is supplied with voltage via the PoE switch, the device
boots up automatically.
The device is in Access-Point mode (the LED lights up permanently red).
System Manual 2CKA001473B5074
Perform a backup after commissioning.
–
If the Smart Access Point becomes defective, without a backup you
would need to re-commission the entire system.
Commissioning
see chapter 3.1.2 "Connecting a PC with
the "Smart Access Point "" on page 33
see chapter 3.1.3 "Preliminary information:
Selection of the system mode" on page 35
see chapter 3.1.4 "Commissioning the
"Smart Access Point"" on page 36
│33