SERVICE MODE LIST This unit provided with the following SERVICE MODES so you can repair, examine and adjust easily. To enter the Service Mode, press both set key and remote control key for more than 2 seconds. Remocon Key Operations Set Key Reset the user setting items (PICTURE, VOLUME and LANGUAGE) to the initial state VOL.
ELECTRICAL ADJUSTMENTS 1. ADJUSTMENT PROCEDURE 2. BASIC ADJUSTMENTS Read and perform these adjustments when repairing the 2-1: CONSTANT VOLTAGE circuits or replacing electrical parts or PCB assemblies. Place the set with Aging Test for more than 15 minutes. Connect the digital voltmeter to TP502. CAUTION Set condition is AV MODE without signal.
Page 4
ELECTRICAL ADJUSTMENTS 2-10: BRIGHT CENT 2-6: FOCUS Receive a 70dB monoscope pattern. Receive the PAL black pattern*. (RF Input) Turn the Focus Volume fully counterclockwise once. Using the remote control, set the brightness and Adjust the Focus Volume until picture is distinct. contrast to normal position.
Page 5
ELECTRICAL ADJUSTMENTS 2-13: TINT Receive the NTSC color bar pattern. (Audio Video Input) Using the remote control, set the brightness and contrast to normal position. Connect the oscilloscope to TP024. Activate the adjustment mode display of Fig. 1-1 and press the channel button (20) on the remote control to select "TINT".
ELECTRICAL ADJUSTMENTS PURITY AND CONVERGENCE 3-3: STATIC CONVERGENCE ADJUSTMENTS NOTE Adjust after performing adjustments in section 3-2. NOTE Receive the crosshatch pattern from the color bar Turn the unit on and let it warm up for at least 30 generator. minutes before performing the following adjustments.
Page 14
WAVEFORMS MICON/TUNER CHROMA/SIF/VIF/21PIN 50µs 20µs 0.5µs 100mV 0.5V 10ms 50µs 100mV 200mV 20µs 20µs 50µs 0.5V 0.2ms 20µs 20µs 50µs 0.2ms 20µs 100mV 100mV NOTE: The following waveforms were measured at the point of the corresponding balloon number in the schematic diagram.
WAVEFORMS DEFLECTION/CRT 20µs 10ms 10ms 20µs 20µs 10ms 100mV 200mV SOUND AMP/FRONT AV 10ms 20µs 200mV 20µs 20µs 20µs 1.00V 500us 20µs 20µs 500mV NOTE: The following waveforms were measured at the point of the corresponding balloon number in the schematic diagram.
Page 16
WAVEFORMS 2µs 200V 20µs 20µs 20µs NOTE: The following waveforms were measured at the point of the corresponding balloon number in the schematic diagram.