Table of Contents
Advertisement
3
3-15 Network Setup options
Network Setup
Protocol Setup
TCP/IP Setup
TCP/IP Setup with Ethernet
Ethernet Setup
Enable TCP/IP for Ethernet
Yes/No [Yes]
Select Yes if you have a TCP/IP network connected to the ColorPASS over Ethernet
cabling.
If you use Token Ring, enabling TCP/IP for Token Ring is required for enabling the
Fiery WebTools.
If you are using TCP/IP for printing from Windows computers, enabling
N
:
OTE
TCP/IP here also enables you to use Fiery utilities from Windows computers using
TCP/IP protocols.
Enable Auto IP Configuration
Yes/No [Yes]
Select Yes to allow the ColorPASS to obtain its Ethernet IP address by searching the
network. Depending on your network and the protocol you select in the following
option (DHCP, BOOTP, or RARP), the IP address can change. Select No to assign the
ColorPASS a static IP address that will not change. If you select No, you proceed to
the IP Address option, where you manually set the IP address.
Advertisement
Table of Contents
