Using The 3D Function - Samsung 450 Series User Manual
Hide thumbs
Also See for 450 Series:
- User manual (129 pages) ,
- Installation manual (71 pages) ,
- E-manual (200 pages)
Table of Contents
Advertisement
Available languages
Available languages
•
Scrolling: This function removes after-images on the screen by moving all the pixels on the PDP according to a pattern. Use
this function when there are remaining after-images or symbols on the screen, especially when you displayed a still image on
the screen for a long time.
•
Side Gray: When you watch TV with the screen ratio of 4:3, the screen is prevented from any damage by adjusting the white
balance on both extreme left and right sides. To prevent the screen burn from happening, select Dark or Light.
- Dark: When you set the screen ratio to 4:3, it darkens the left and right sides.
- Light: When you set the screen ratio to 4:3, it brightens the left and right sides.
To remove after-images on the screen, use the Scrolling function.
N
The after-image removal function has to be executed for a long time (approximately 1 hour) to effectively remove after-images
N
on the screen. If the after-image is not removed after performing the function, repeat the function again.
Press any key on the remote control to cancel this feature.
N
Using the D Function
You can enjoy D movies and games on your TV. The D function enables you to view D images using special D glasses.
Connections
❑
D Glasses
(Not supplied)
The appearance of the 3D glasses (including Emitter) may differ depending on the model of your glasses.
N
1. Connect a HDMI/DVI cable between the HDMI IN 2(DVI) jack on the TV and the PC output jack on your computer.
. Connect a 3.5mm Stereo Audio Cable between the PC / DVI AUDIO IN jack on the TV and the Audio Out jack of the sound card on
your computer.
. Connect the Emitter to the 3D SYNC OUT port on the rear panel of the TV.
4. Turn the TV on and set the source of the TV to HDMI2/DVI.
For more information on the 3D glasses (including the Emitter), refer to the user manual of your 3D glasses.
N
Adjust the PC resolution: - PL42B450B1: 1024 x 768@60Hz
N
Optimum PC resolution for PL50B450B1 is 1360x768. When 1024x768 signal is connected in 3D mode, the picture will be shown in
N
4:3 format with left and right side grey bars appeared.
The 3D IR Emitter communicates with the 3D glasses.
N
Therefore, make sure the 3D IR Emitter is located near the 3D glasses.
It is activated when the HDMI or DVI input signal is RGB, and DVI Sound is supported.
N
When the power is turned on or off, the mode changes to the default (Off) and the Format is saved.
N
To use the 3D Effect function, a graphics card supporting 3D or 3D software is required.
N
The 3D glasses and the Emitter must be manufacturer by the same company.
N
If you play a game or watch TV while wearing the 3D glasses for long periods of time, you may experience eyestrain or a headache.
N
3D glasses (including the Emitter) not manufactured by Samsung may not be supported.
N
If you find the screen flickering while the 3D function is used, darken the room for the best viewing conditions.
N
D IR Emitter
(Not supplied)
- PL50B450B1: 1024 x 768@60Hz,1360 x 768@60Hz
English - 4
PC
.5mm Stereo Audio Cable (Not supplied)
1
HDMI/DVI Cable (Not supplied)
TV Rear Panel
Continued...
Advertisement
Table of Contents
Troubleshooting
