Table of Contents
Advertisement
•
The servo gain of each robot axis is automatically changed according to the
set load conditions.
b)
Program examples
Basic program examples using the PAYLOAD command are shown below. For
further information, see the Robot Language Manual.
(Program example 1)
The robot is moved under the load conditions of 5 kg mass and 100 mm gravity
center offset.
PROGRAM SAMPLE
SPEED=100
PAYLOAD={5,100}
MOVE P1
MOVE P2
STOP
END
(Program example 2)
When the hand mass is 3 kg and the gravity center offset is 30 mm, and the mass
is 5 kg and gravity center offset is 50 mm when the workpiece is grasped.
Pick-and-place operation is executed under the above conditions.
PROGRAM SAMPLE
PAYLOAD={3,30}
ACCUR=COARSE
ENABLE NOWAIT
RESET DOUT
MOVE P0
DOUT(1)
WAIT DIN(1)
LOOP:
MOVE P1+POINT(0,0,100)
IF DIN(-1)THEN GOTO FIN
MOVE P1
WAIT MOTION>=100
DOUT(213)
DELAY 1
PAYLOAD={5,50}
MOVE P1+POINT(0,0,100)
MOVE P2+POINT(0,0,100)
MOVE P2
WAIT MOTION>=100
DOUT(-213)
TRANSPORTATION AND INSTALLATION MANUAL
– 70 –
STE80753
Advertisement
Table of Contents
