Beater To Bowl Clearance; Placing/Removing The Pouring Shield - KitchenAid 5KSM45 Manual
Hide thumbs
Also See for 5KSM45:
- User manual (404 pages) ,
- Manual (404 pages) ,
- Instructions manual (244 pages)
Table of Contents
Advertisement
USING THE STAND MIXER
BEATER TO BOWL CLEARANCE
Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of the
bowl. If, for any reason, the flat beater hits the bottom of the bowl or is too far away from
the bowl, you can correct clearance easily.
1
Turn speed control to "0". Unplug Stand
Mixer.
NOTE: When properly adjusted, the flat beater will not strike on the bottom or side of
the bowl. If the flat beater or the wire whip is so close that it strikes the bottom of the
bowl, coating may wear off the beater or wires on whip may wear.
PLACING/REMOVING THE POURING SHIELD*
1
To place pouring shield: Turn speed
control to "0". Unplug Stand Mixer.
Attach your chosen accessory. See the
"Attaching/removing the flat beater, wire
whip, or dough hook" section.
*Included with select models only. Also available as an optional accessory.
8 |
W11389352A.indb 8
2
Lift motor head. Turn screw slightly
counterclockwise (left) to raise flat beater
or clockwise (right) to lower flat beater.
Make adjustment with flat beater, so
it just clears surface of bowl. If you
overadjust the screw, the bowl lock lever
may not lock into place.
2
From the front of the Stand Mixer, slide
the pouring shield over the bowl until the
shield is centred. The bottom rim of the
shield should fit within the bowl.
11/22/2019 11:52:27 AM
- Quick Links:
- Parts and Features
Hide quick links:
Advertisement
Table of Contents
