Replacing The Optical Drive - HP ProOne 400 Maintenance And Service Manual
Hide thumbs
Also See for ProOne 400:
- Hardware reference manual (40 pages) ,
- Hardware reference manual (49 pages)
Table of Contents
Advertisement
Replacing the optical drive
The optical drive is located beneath the lower hard drive on the left side of the computer. The green latch
comes with the drive.
1.
Prepare the computer for disassembly (see
2.
Remove the rear port cover (see
3.
Remove the stand (see
4.
Remove the access panel (see
5.
Remove the hard drive (see
6.
Push and hold the green tab (1) while pushing in the green latch (2) at the back of the optical disc drive
enclosure and slide the drive out of the chassis (3).
7.
Pull the green latch off the optical disc drive.
Keep this latch to install on the new optical disc drive.
8.
Align the three pins on the latch with the holes in the new optical disc drive and press the latch firmly
onto the new drive.
NOTE:
30
Chapter 4 Removal and Replacement Procedures
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
Removing a 2.5-inch hard disc drive on page
You must reuse the latch removed from the old optical disc drive.
Preparing to disassemble the computer on page
23).
20).
24).
19).
27).
Advertisement
Table of Contents
