Drives
For a list of available drives, see
Drive positions
Drive positions
1
3.5-inch secondary hard drive bay
2
3.5-inch primary hard drive bay
3
2.5-inch hard drive bay
4
9.5 mm slim optical drive bay
NOTE:
The drive configuration on your computer may be different than the drive
configuration shown above.
Installing and Removing Drives
When installing drives, follow these guidelines:
●
The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA connector on
the system board labeled SATA0.
●
Connect secondary hard drives and optical drives to one of the light blue SATA connectors on the system
board (labeled SATA1, SATA2, and SATA3).
IMPORTANT:
If you are inserting or removing a drive, shut down the operating system properly, turn off the computer, and
unplug the power cord. Do not remove a drive while the computer is on or in standby mode.
Before handling a drive, be sure that you are discharged of static electricity. While handling a drive, avoid
touching the connector.
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields such as
monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the
package "Fragile: Handle With Care."
32
Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
Drives on page
To prevent loss of work and damage to the computer or drive:
10.