Error Indications - Panasonic KY-A227D Operating Instructions Manual
Hide thumbs
Also See for KY-A227D:
- Installation instructions (4 pages) ,
- Operating instructions manual (34 pages)
Table of Contents
Advertisement
Troubleshooting
Symptom
■
Sound and noise
• Various resonant sounds may be heard depending on the
type of cookware. You may feel small vibration when you
hold the handle, or the cookware may slightly move.
Noise is heard
→ This is not a malfunction. Moving the cookware
while heating.
slightly or replacing it may stop the sound.
• If the cookware is removed while heating, a short
metallic sound may be heard.
Even after the
• The cooling fan is operating because the inside of the
main power
appliance is still hot.
switch is turned
( As the appliance cools down, it will automatically
off, noise from the
stop.)
fan is still heard.
■
Heating power
• Overheating prevention function
If the bottom of the cookware overheats, for example, by
preheating too long, the heating power will be reduced
automatically without changing the heat level indication.
The heating
( The heating power returns to normal after the
power of the IH
cookware cools down.)
heater seems
weaker.
• Cookware, such as ceramic and earthenware pots,
which cause the IH heater to overheat are used.
→ Do not use ceramic ware and earthenware even if
they are made for induction heating.
When both the right
and left IH heaters are
used simultaneously,
• The heating power is automatically controlled so that
• The heating
overall power consumption does not exceed the limit.
power is reduced
(P.23)
or a lower heat
* The heat level may decrease automatically.
level is indicated.
Even after touching
• The heat level
and the appliance may beep.
cannot be
increased.
20
Probable cause
, the level may not increase
Error Indications
If any of the following error indications appears, check the cause and deal with it.
After the cause is eliminated, touch
will disappear.
• You can also clear the
error with
Indication
• The intake or exhaust vent is clogged with dust,
etc.
→Remove any blockage.
Filter clog detection
• An empty pot has been heated.
→ Put ingredients into the pot and touch the key
or
again.
* This function may not operate properly depending
on the type of pot, or if the heat level is low.
Empty pot auto shutoff
• "Congee menu" was used while the top plate is
hot.
• An empty pot has been heated with "Congee
Top plate high
menu".
temperature detection
→ After the top plate cools down, touch the key
(for congee)
again.
or
. Then, the error indication
.
Probable cause
21
Hide quick links:
Advertisement
Table of Contents
