Table of Contents
Advertisement
3 Get started
Always follow the instructions in this chapter in
sequence.
Connect speakers
Note
•
Insert the stripped portion of each speaker wire into
the socket completely.
•
For better sound quality, use the supplied speakers only.
•
Connect only speakers with impedance that is the
same or higher than the supplied speakers (refer to the
"Specifications" section of this manual).
1
For the right speaker, find the sockets on
the the main unit marked "RIGHT".
2
Insert the red wire into the red (+) socket,
the black wire into the black (-) socket.
3
For the left speaker, find the sockets on the
main unit marked "LEFT".
4
Repeat step 2 to insert the left speaker
wire.
8
EN
To insert each speaker wire:
1
Hold down the socket flap.
2
Insert the speaker wire fully.
3
Release the socket flap.
Connect power
Caution
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back of the micro system.
•
Before connecting the AC power cord, make sure that
you have completed all other connections.
Connect the AC power cord to the power
outlet.
Prepare the remote control
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
To install the remote control battery:
1
Open the battery compartment.
2
Insert 2 AAA batteries (not supplied) with
correct polarity (+/-) as indicated.
Advertisement
Table of Contents
