Table of Contents
Advertisement
5.1.2
Transporting the robot arm
Risk of injury due to loss of stability
The robot arm can tip, fall down and trap persons.
„
Ensure stability of the robot arm when removing it from the transport pallet or
installation surface.
Make sure that removal of the robot arm is always performed by at least two
„
employees.
Risk of injury due to use of unsuitable transport gear.
Danger to life due to falling parts if unsuitable transport gear is used for transport
of the robot.
Only lift the robot with the transport devices included in the scope of delivery
„
and on the tested load-bearing points.
Use only suitable transport gear and fasteners with sufficient bearing load.
„
Risk of falling due to eccentric center of gravity
In case of incorrect fastening, the robot arm can tip and cause life-threatening
injuries.
Make sure that the instructions for transport of the robot arm are adhered to.
„
Risk of damage
If force is applied to the sensor skin, the sensor system can be damaged.
Lifting the robot arm at the sensor skin is not permitted. Only light guiding is
„
permitted.
The sensor skin must not be pinched by lifting gear.
„
„
Set down the robot arm only at the prepared installation location.
Otherwise there is a risk of tipping and damage.
Before transporting the robot arm, make sure that the following conditions are met:
• The robot arm is in its transport position.
• The robot arm is undamaged.
• The transport areas are free of obstacles and the transport route is secured.
• The stability of the transport gear, including the moving load, is ensured.
• The robot arm is secured by the transport gear until it is securely fastened at the
installation location.
Specification of the transport gear
Description
Crane, lifting gear and shackles
Rope length
3 842 565 050/2019-11 APAS assistant K1100-10i V01.00.00 - V01.00.99, Bosch Rexroth AG
Transport and storage
DANGER
WARNING
NOTICE
Specification
Load-bearing capacity > 100 kg
min. 1,500 mm
39/68
Advertisement
Table of Contents
