Rated current 0.45 A Power consumption Approx. 19 W (ISO10561 Letter Pattern) Approx. 3.5 W in standby mode * Check the label on the back of the printer for your printer’s voltage. EPSON Stylus Photo 785EPX Environmental Temperature Operation...
Page 3
Always load paper into the sheet feeder short edge first, except for envelopes. Load envelopes flap edge first with the flap side down Since the quality of any particular brand or type of paper may be changed by the manufacturer at any time, EPSON cannot attest to the quality of any non-EPSON brand or type of paper.
The minimum top margin is 0.12 inch (3.0 mm). When loading multiple sheets of EPSON Photo Quality Glossy Film, the minimum top margin is 1.2 inches (30.0 mm). B-L: The minimum left margin is 0.12 inch (3.0 mm).
Don’t place the cartridges under the hooks; you may damage the clamp when you close it. 6. Lower the clamps so they snap shut. 7. Press the e ink replacement button and close the printer cover. Ink charging takes about two minutes. You will see the lights flash and hear the printer make noise.
❏ Some special media have a cut corner that you need to position in the upper right corner when you load it. ❏ You can load the following number of sheets of EPSON special media: For this paper name...
Use these EPSON ink cartridges within six months of installing them and before the expiration date on the package: ❏ Black ink cartridge: T007201 (U.S.), T007311 (Canada) ❏...
EPSON Stylus Photo 785EPX 4. Lift the cartridge out of the printer and dispose of it carefully. Keep ink cartridges out of the reach of children and do not drink the ink. If ink gets on your hands, wash them thoroughly with soap and water.
Load paper that’s at least 8.27 inches (210 mm) wide to prevent ink from spraying inside the printer and smudging your printouts. For the best results, load EPSON Photo Quality Ink Jet Paper in the printer whenever you check the print head alignment.
Follow these steps: 1. Turn on the printer, wait until the print head locks in the far right position, then turn off the printer. 2. Unplug the power cord from the electrical outlet. Then disconnect the printer cable from the printer.