Sealing The Bag Early - Miele EVS 7010 Operating And Installation Instructions
Built-in vacuum drawer
Hide thumbs
Also See for EVS 7010:
- Operating and installation instructions (56 pages) ,
- Operating and installation instructions (56 pages) ,
- Operating and installation instructions (64 pages)
Table of Contents
Advertisement
Operation
After the vacuuming process
A signal sounds.
Open the glass lid.
Danger of burning due to hot
surfaces.
The sealing bar and weld seam are
hot.
Do not touch the sealing bar or the
weld seam immediately after the
vacuuming process.
Remove the vacuum sealing bag from
the vacuum chamber.
Before starting a new vacuuming
process, check that the vacuum
chamber and the sealing bar are
clean and dry.
Remove any soiling or liquid residues
if necessary.
24
Sealing the bag early
You can end the vacuuming process
before reaching the selected vacuum
settings and seal the bag early.
Touch the sensor control.
The vacuuming process stops. After a
few seconds the bag will be sealed.
Successful sealing of the bag is only
possible when there is a minimum
vacuum (vacuum setting 1) in the
chamber.
Touch the sensor control again if
the required vacuum setting has not
yet been reached. For technical
reasons, a few seconds will elapse
before the bag is sealed.
Advertisement
Table of Contents
