Character fonts: ribbon cartridge 1/94 ActionPrinter 3260 24-pin impact dot matrix Bidirectional logic-seeking for text and graphics. (Unidirectional for graphics can be selected with the default-setting mode or the proper software command.) 1/6 inch, 1/8 inch, or programmable in 1/360-inch increments 111 ms per 1/6-inch line;...
Page 2
Note: You can use recycled paper with this printer under normal temperature conditions; however, you may notice an increase in ribbon consumption and paper jamming. If this occurs, use a higher grade paper.
Page 3
Storage: Safety approvals Safety standards: R.F.I.: Initialization The printer can be initialized (returned to a fixed set of conditions) in three ways: Default settings The table below shows the default settings that become valid 1 million characters when the printer is initialized.
The control panel lights provide information on certain printer conditions and settings. READY The READY light is on when the printer is ready to receive data from the computer. The READY light flashes under these conditions: D When you turn on the printer...
FONT buttons at the same time to move the paper back to the paper-park position. Caution: Never feed labels backward; they may peel off their backing sheet and damage the printer. Use the FF button to feed them forward. Other control-panel features The control panel also gives you access to three special...
Note: You can repeat steps 5 through 7 if you want to make more than one change. Also, you can turn off the printer and start over if you are not sure about a setting. 1. Make sure the printer is turned off and paper is loaded in the paper cassette.
Page 7
0 o f f 6 flashing 0 on 0 off 8 flashing 8. Turn off the printer to exit the default-setting mode. Any changes you have made remain in effect until you change them again. Loading Paper and Running the Self Test You can run the self test with either continuous paper or single sheets;...
In the list of printers box, select Epson ActionPrinter 3260. If ActionPrinter 3260 is not available, select Epson LQ-860 or Epson LQ-2550 if you plan to use color. If you do not plan to use color, choose Epson Stylus 800, Epson LQ-570+, Epson AP-3250, or Epson LQ-870.
To take the full advantage of your printer’s features, choose ActionPrinter 3260. If it is not available, select LQ-860 or LQ-2550 if you plan to use color. If you do not plan to use color, choose Stylus 800, LQ-570+, ActionPrinter 3250, or LQ-870.
Page 10
Be sure to raise the flap when you are not using manual insertion. ClldiOtl: Be sure to turn on the printer before you insert the page into the slot. lf you turn on the printer after paper insertion, the printer prints on the platen without loading the paper.
3. Hold the tractor as shown and fit the edges of both sides into the slots at the back of the printer. Then lift it straight up until you hear the unit snap into place. 4. Raise the paper-release lever and push it firmly into the continuous-paper position.
Page 12
The optional color upgrade kit includes these items. NizJ bracket 1. Put the motor unit in the printer, as shown below, grasping the installation tab. 1/94 motor unit 24-Pin Printers...
Make sure the pins under the ribbon cartridge are placed correctly inside of the bracket as shown below. Move the print head to the middle of the printer and move the sliding part of the ribbon to the middle of the ribbon cartridge.
The color ribbon angle may need adjusting. Move the color ribbon adjustment lever to change the ribbon angle slightly as shown below: Troubleshooting Tips ActionPrinter 3260 Beep Codes Error Display Error Status Cause Beeper sounds...