L1210/L3210
Start Here
IMPORTANT: Before using this product, make sure you read
these instructions and the safety instructions in the online User's
Guide.
The illustrations show the L3210, but the steps are the same for
the L1210, unless otherwise specified.
Not all products are available in all regions.
Note:
1
Unpack
Do not open the ink bottles until you are ready to fill the ink
Note:
tanks. The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
2
Connect the power cord to the back of the product and to
an electrical outlet.
Do not connect to your computer yet.
Caution:
2
Fill ink tanks
Keep the ink bottles out of the reach of children and do not
Warning:
drink the ink.
This product requires careful handling of ink. If ink spills,
Caution:
wipe it off immediately with a damp towel to avoid permanent stains.
If ink gets on your clothes or belongings, it may not come off.
Note:
• Epson cannot guarantee the quality or reliability of third-party ink.
• Use the ink bottles included with the printer to set up the product.
Part of the ink will be used to charge the print head. These bottles
will print fewer pages compared with replacement ink bottles.
• Epson strongly recommends the use of genuine ink to ensure
optimal print quality and performance.
1
Open the ink tank cover, then open the cap for the
black (BK) ink tank.
Refer to the color-coded sticker on the ink tank unit to
Note:
identify the color of each tank.
2
Unpack the black (BK) ink bottle. Hold the ink bottle
upright and slowly turn the bottle cap to remove it.
Do not shake or squeeze the ink bottle. Do not touch
Caution:
the top of the ink bottle after its cap is removed.
3
Insert the ink bottle into the filling port.
Do not force the bottle into position; each bottle is keyed
Note:
for each color.
4
Wait for the ink to fill the tank.
Do not squeeze the bottle or
allow it to contact any other
surface.
Ink flows into the tank and
Note:
stops automatically when the ink
tank is filled to the upper line. If ink
does not flow from the bottle, lift and
reinsert the bottle.