LG ABNW18GBHC0 Engineering Product Data Book page 20
Hide thumbs
Also See for ABNW18GBHC0:
- Owner's manual (24 pages) ,
- Owner's manual (23 pages) ,
- Owner's manual (84 pages)
Advertisement
Compact
9. Installation
9.2 Selection of the best location
Install the air conditioner in the location that satisfies the fol-
lowing conditions.
• The place shall easily bear a load of the indoor unit.
• The place should have enough area for inspection as
shown in figure.
• The place where the unit shall be leveled.
• The place shall allow easy water drainage.(Suitable dimen-
sion "H" is necessary to get a slope to drain as figure.)
• The place shall easily connect with the outdoor unit.
• The place where the unit is not affected by an electrical noise.
• The place where air circulation in the room will be good .
• There should not be any heat source or steam near the unit.
[Unit : mm]
9.3 Ceiling dimension, also hanging
bolt location and service space
1) Select an installation site where the following con-
ditions are fulfilled and also that meets with your
customer's approval.
• If supporting structural members are not strong enough
to take the units weight, the unit could fall out of place
and cause serious injury.
• Where sufficient clearance of maintenance and service
can be ensured.
• Where optimum air distribution can be ensured.
• Where nothing blocks the air passage.
• Where condensate can be properly drained.
• Where piping between indoor and outdoor units is pos-
sible within the allowable limit (Refer to the installation
manual of the outdoor unit.)
• Keep the indoor and outdoor units, power cable and
transmission wiring, at least 1 m from TVs and radios,
to prevent distorted pictures and static.(Depending on
the type and source of the electrical waves, static may
be heard even when more than 1 m away.)
14 _
Ceiling concealed duct - Middle static pressure
Indoor unit
H= 20 or more
NOTE
If the service panel is at the top of the unit, then provide
sufficient service clearance as per convenience.
2) Relative positions of indoor unit, suspension bolt
and inspection hatch size
[BH Chassis]
932
[Unit : mm]
120
Inspection
hatch 600 x 600
Advertisement
