Table of Contents
Advertisement
Switch module removal and installation
Removing a Switch Module
1.
Pull out the release handle to the open position (1) and push in the direction indicated ( 2) and pull the
module out of the bay (3). .
2.
Replace immediately with another module or with a dummy module cover to maintain airflow integrity.
Installing a Switch Module
1.
Make sure the cover to the module has been installed before proceeding.
2.
Remove the dummy cover from the bay you want to place the module in.
3.
Place the module's release handle in the open position.
4.
Slide the module into the module bay until it stops.
5.
Push the release handle to the closed position.
NOTE: After the module has been installed and the handle locked, it will turn on and a POST test will run to
verify it is working properly. If there are no problems the blue Init. OK LED on the module will illuminate
and you will see an OK under I
NOTE: If the module is installed in a top bay it must be positioned upside-down.
Hardware removal and installation
in the G
E S
NITIATED
B
WITCH
screen of the management software utility.
33
Advertisement
Table of Contents
