Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION (REMOTE MOTOR UNIT)
The Range Hood can be connected to the under-roof (URS) remote motor unit.
In the case of an under-roof motor unit (URS), it must be placed next to the technical compartment inside the home, protected
against atmospheric agents and within reach for any maintenance operations.
In the case of installation with remote motor, you must connect the Range Hood to the electrical system earthing
(after having verified its functioning) by means of a suitable cable.
To execute this operation, use the threaded insert set up in the Range Hood structure and identified with a label and symbol
It is recommended that you comply with the current regulations on electrical safety of systems and devices regarding earthing
equipment.
Unfasten screws and 4 washers, remove the bracket (D) and the motor flange (E) from the motor unit (G)
(Fig.
).
1
1
Reassemble to straight exhaust direction by rotating the flange (F) of the motor unit (G) (Fig.
Secure the brackets (D) to the motor unit (G) using the 6 screws (V2, V7 Ø4.2×12.5) (Fig.
S
x4
Additionally install reinforcement wooden frames between the joists in the ceiling (Fig.
Secure the motor unit (G) to the reinforcement wooden frame using the 4 screws (V8 Ø5×50) (Fig.
J
D
1
(x2)
Joist
V2
Ø4.2×12.5
V3
8 - Ø3.9×9.5,
4 - washer
3
V2 Ø4.2×12.5
(Fig.
)
1
V7 5- Ø4.2×12.5
(Accessory)
4
12 9/32"
Joist
312mm
(Top View)
22
2
Keep screws to secure
Reinforcement
the brackets (D) to
wooden frame
the motor unit (G)
(Fig.
)
5
G
E
G
D
D
Joist
Reinforcement
wooden frame
2
washer
F
8 - screw
Ø3.9×9.5
4 - washer
8 - screw
(Bottom view)
5
Joist
2
).
).
3
).
4
).
5
washer
F
V3
8 - Ø3.9×9.5,
4 - washer
G
V8
4 - Ø5 × 50
Joist
Reinforcement
wooden frame
.
E
Advertisement
Chapters
Table of Contents
