Advertisement
Quick Links
Quick
Installation Guide
This Quick Installation Guide contains important information and notes regarding the
installation of Philips InstantFit LED T8 with EasySmart technology. You will be
instructed to install the lamps and commission them into controlled network(s) with
this guide.
Advertisement
Related Manuals for Philips EasySmart InstantFit t8
Summary of Contents for Philips EasySmart InstantFit t8
- Page 1 Quick Installation Guide This Quick Installation Guide contains important information and notes regarding the installation of Philips InstantFit LED T8 with EasySmart technology. You will be instructed to install the lamps and commission them into controlled network(s) with this guide.
- Page 2 B B e e f f o o r r e e Y Y o o u u S S t t a a r r t t Please read carefully the important points regarding Philips InstantFit LED T8 with EasySmart technology: Product is dimmable by wireless control. DO NOT use with dimmer. Operating ambient temperature from -20°C to +45°C. Suitable to replace T8 fluorescent lamps that operate on verified ballasts only*. Must be used with compatible control devices*. NOT intended for use in emergency luminaires. NOT compatible with luminaires that use a remote starter. Modifications to the product void the warranty. *Please refer to www.philips.com/EasySmart for latest compatibility list. P P l l a a n n t t h h e e I I n n s s t t a a l l l l a a t t i i o o n n It is important to plan how networks will be deployed before commencing installation work. While planning,...
- Page 3 S S e e t t U U p p t t h h e e N N e e t t w w o o r r k k ( ( s s ) ) Following two steps are needed to set up the network(s). INSTALL ALL DEVICES: You can easily replace your fluorescent T8 lamps with LED lamps in this box following the steps below. 1. Switch off power to the luminaire. 2, 3. Remove the existing fluorescent lamps. 4, 5. Install the Philips InstantFit LED T8 with EasySmart technology. 6. Switch on the power to luminaire. All sensors and switches also need to be properly installed and powered on. Please refer to manufacturer’s installation instructions. COMMISSION THE NETWORK(S): InstantFit LED T8 with EasySmart Technology are designed to be easily added to a network that contains sensor and switch. After power-on, lamps will look for available network automatically. In some cases where a more controlled commissioning is preferred, we also provide an option to allow only registered lamps to join the network. This can be done by scanning the unique Quick Response...
- Page 4 Troubleshooting Performing factory reset will restore a lamp to its default state. It will be removed from its current network (if any) and all settings will be deleted. Usually factory reset is needed in case of wrong commissioning. To reset a lamp, point the EasySmart IR programming tool to the lamp. Press ‘identification’ button. Lamp will start blinking. • Press ‘reset’ button • • After two longer blinks, lamp will first turn OFF and then ON to indicate successful reset. CAUTION – IF THE LAMP OR LUMINAIRE EXHIBITS UNDERSIRABLE OPERATION (BUZZING, FLICKERING, ETC.) IMMEDIATELY TURN OFF POWER, REMOVE LAMP FROM LUMINAIRE AND CONTACT THE MANUFACTURER. CAUTION – RISK OF FIRE. DO NOT INSTALL IN A PRE-HEAT LUMINAIRE. THIS LAMP ONLY OPERATED ON ELECTRONICS BALLAST.