Specifications - Sony STR-DG820 Operating Instructions Manual
Multi channel av receiver
Hide thumbs
Also See for STR-DG820:
- Operating instructions manual (108 pages) ,
- Service manual (96 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 Hz – 20,000 Hz; rated 100 watts per
channel minimum RMS power, with no more
than 0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
1)
Power Output
Minimum RMS Output Power
(8 ohms, 20 Hz – 20 kHz, THD 0.09%)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 0.7%)
Surround Mode Output Power
(8 ohms, 1 kHz, THD 10%)
1)
Measured under the following conditions:
120 V AC, 60 Hz
2)
Reference power output for front, center, surround
and surround back speakers. Depending on the
sound field settings and the source, there may be
no sound output.
Frequency response
Analog
Input
Analog
Digital (Coaxial) Impedance: 75 ohms
Digital (Optical)
104
US
100 W + 100 W
110 W + 110 W
2)
150 W per channel
10 Hz – 70 kHz,
+0.5/–2 dB (with sound
field and equalizer
bypassed)
Sensitivity: 500 mV/
50 kohms
3)
S/N
: 96 dB
4)
(A, 500 mV
)
S/N: 100 dB
(A, 20 kHz LPF)
S/N: 100 dB
(A, 20 kHz LPF)
Output (analog)
AUDIO OUT
SUBWOOFER
Equalizer
Gain levels
3)
INPUT SHORT (with sound field and equalizer
bypassed).
4)
Weighted network, input level.
FM tuner section
Tuning range
Antenna (aerial)
Antenna (aerial) terminals
Intermediate frequency
AM tuner section
Tuning range
With 10-kHz tuning scale:
With 9-kHz tuning scale:
Antenna (aerial)
Intermediate frequency
5)
You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off
the receiver. While holding down TUNING
MODE, press POWER on the receiver. All preset
stations will be erased when you change the tuning
scale. To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure.
Video section
Inputs/Outputs
Video:
COMPONENT VIDEO:
Voltage: 500 mV/
10 kohms
Voltage: 2 V/1 kohm
±10 dB, 1 dB step
87.5 MHz – 108.0 MHz
FM wire antenna (aerial)
75 ohms, unbalanced
10.7 MHz
5)
530 kHz – 1,710 kHz
5)
531 kHz – 1,710 kHz
Loop antenna
450 kHz
1 Vp-p, 75 ohms
Y: 1 Vp-p, 75 ohms
P
/C
: 0.7 Vp-p, 75 ohms
B
B
P
/C
: 0.7 Vp-p, 75 ohms
R
R
80 MHz HD Pass Through
Hide quick links:
Advertisement
Table of Contents
