Siemens SIMATIC NET RUGGEDCOM RX1512 Installation Manual page 40

Rugged multi service platforms

Hide thumbs Also See for SIMATIC NET RUGGEDCOM RX1512:

Table of Contents

Electrical hazard – risk of power failure

Do not install more than one RUGGEDCOM APE module. Installing more than one of

this type of module can lead to power fluctuations and irregular shut downs.

Contamination hazard – risk of equipment damage

Prevent the ingress of water, dirts and other debris that may lead to premature

equipment failure. Always make sure slots are not left empty and open ports are

protected with plugs or covers.

Note

Only one WAN line module is supported per chassis.

Removing a Module

To remove a line module, do the following:

RUGGEDCOM RX1512

Installation Manual, 04/2021, C79000-G8976-1057-20

NOTICE

[Optional] If the device is installed in a rack, remove it from the rack.

Loosen the screws that secure the module.

Pull the module from the chassis to disconnect it.

Module

Chassis

Screw

Figure 4.2

Removing a Module

Install a new module or a blank module (to prevent the ingress of dust and dirt).

[Optional] If necessary, install the device in the rack.

4.3 Installing/Removing Line Modules

Modules

Table of Contents

Ruggedcom rx1512 Simatic net