Dell 4100 Installation And Troubleshooting Manual page 67
Dell poweredge 4100 servers: install guide
Hide thumbs
Also See for 4100:
- Manual (160 pages) ,
- Solution manual (146 pages) ,
- User manual (139 pages)
Table of Contents
Advertisement
2.
If the system configuration settings are incorrect,
make the necessary corrections in the System
Setup program, and then reboot the system.
3.
Run the Diskette Drives Test Group in the system
diagnostics to see whether the diskette drive sub-
system now works correctly.
See Chapter 5, "Running the System Diagnostics,"
for more information.
Do the tests complete successfully?
Yes. Continue with the next step in the procedure you
were performing.
No. See Chapter 11, "Getting Help," for instructions
on obtaining technical assistance.
Diskette-Drive Subsystem
Troubleshooting
Follow these steps to troubleshoot the diskette drive
subsystem:
1.
Turn off the system, including any attached
peripherals, and disconnect all the AC power
cables from their power sources.
2.
Remove both computer covers.
See "Removing the Computer Covers" found earlier
in this chapter.
CAUTION: See "Protecting Against Electro-
static Discharge" in the safety instructions at
the front of this guide.
3.
Check the diskette drive cabling.
Is the diskette drive securely connected to the proper
diskette drive interface cable connector? Is the dis-
kette drive interface cable connector securely
connected to the interface connector (labeled
"FLOPPY") on the system board? Is the drive's DC
power cable firmly connected to the drive?
Yes. Go to step 5.
No. Go to step 4.
4.
Reconnect the cable connectors.
5.
Replace the computer covers, reconnect the sys-
tem to AC power, and turn on the system.
7-16
Dell PowerEdge 4100/180 and 4100/200 Systems Installation and Troubleshooting Guide
6.
Run the Diskette Drives Test Group in the system
diagnostics to see whether the diskette drive sub-
system now works correctly.
See Chapter 5, "Running the System Diagnostics,"
for more information.
Do the tests complete successfully?
Yes. You have fixed the problem.
No. Go to step 7.
7.
Repeat steps 1 and 2, and remove all expansion
cards.
See "Expansion Cards" in Chapter 8 for instructions.
8.
Replace the computer covers, reconnect the sys-
tem to AC power, and turn on the system.
9.
Run the Diskette Drives Test Group in the system
diagnostics to see whether the diskette drive sub-
system now works correctly.
Do the tests complete successfully?
Yes. An expansion card may be conflicting with the
diskette drive logic, or you may have a faulty expan-
sion card. Go to "Checking the Diskette Drive
Subsystem" found earlier in this chapter.
No. Go to step 10.
10. Repeat steps 1 and 2, and reinstall one of the
expansion cards you removed in step 7.
See "Removing an Expansion Card" and "Installing
an Expansion Card" in Chapter 8 for instructions.
11. Replace the computer covers, reconnect the sys-
tem to AC power, and turn on the system.
12. Run the Diskette Drives Test Group in the system
diagnostics to see whether the diskette drive sub-
system now works correctly.
Do the tests complete successfully?
Yes. Go to step 13.
No. Go to step 14.
13. Repeat steps 10 through 12 until all expansion
cards have been reinstalled or until one of the
expansion cards prevents the system from boot-
ing from the Dell Server Assistant CD.
Advertisement
Table of Contents
Troubleshooting
