Table of Contents
Advertisement
Section 3 - Configuration
Motion:
Click on the Motion button to enable
motion detection.
Sets the measurable difference between
Sensitivity:
two sequential images that would
indicate motion.
Percentage:
Sets the amount of motion in the window
being monitored that is required to
initiate a motion detected alert. If this is
set to 100%, motion is detected within
the whole window to trigger a snapshot.
Note: Setting a higher sensitivity and
a lower percentage makes any motion
more easily detected.
Click to open the corresponding motion
Zone 1-3:
window.To assign a name to the window,
enter the desired name in the entry field
next to the zone button.
Save:
Saves the related settings of that window.
Click to open the Motion Screen Display. The MSD window allows you to monitor the amount of motion
Open MSD:
detected in each motion window. The graphic bars will increase or decrease depending on the image
variation. A blue bar means the image variation is under the monitoring level, and no motion detection alert
is triggered. A red bar means the image variation is over the monitoring level and a motion detected alert
is triggered.
D-Link DCS-1110 User Manual
Motion Detection
36
Advertisement
Table of Contents
