Wall Mount; Product Specifications - Philips HTL3142S User Manual

Table of Contents

Advertisement

6 Wall mount

Note
Improper wall mounting may result in accident, injury or
damage. If you have any query, contact Consumer Care
in your country.
Before wall mounting, make sure the wall can support
the weight of your SoundBar.
Before wall mount, you need not remove the four
rubber feet at the bottom of the SoundBar, otherwise
the rubber feet cannot be fixed back.
Screw length/diameter
Depending on the type of wall mounting your
SoundBar, make sure that you use screws of a
suitable length and diameter.
3.5-4mm
> 25mm
See the illustration in the quick start guide on
how to wall mount the SoundBar.
1) Drill two holes on the wall.
2) Secure the dowels and screws in the holes.
3) Hang the SoundBar on the fastening screws.
4mm
7 Product
specifications
Note
Specifications and design are subject to change without
notice.
Amplifier
Total output power: 280W RMS
(+/- 0.5 dB, 10% THD)
Frequency response: 20 Hz-20 kHz / ±3 dB
Signal-to-noise ratio: > 65 dB (CCIR) /
(A-weighted)
Input sensitivity:
AUX: 900 mV
AUDIO IN: 500 mV
Audio
S/PDIF Digital audio input:
Coaxial: IEC 60958-3
Optical: TOSLINK
USB
Compatibility: Hi-Speed USB (2.0)
Class support: USB Mass Storage Class
(MSC)
File system: FAT16, FAT32, NTFS
Supports MP3 and WMA file formats
Sampling frequency:
MP3: 8 kHz, 11 kHz, 12 kHz, 16 kHz,
22 kHz, 24 kHz, 32 kHz, 44.1 kHz,
48 kHz
WMA: 44.1 kHz, 48 kHz
Constant bit rate:
MP3: 8 kbps-320 kbps
WMA: 32 kbps-192 kbps
Version:
WMA: V7, V8, V9
EN
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Htl3142s/12

Table of Contents