Configuring Wired Wan Connection - D-Link AC1200 User Manual
Wi-fi gigabit router
Hide thumbs
Also See for AC1200:
- User manual (175 pages) ,
- Quick installation manual (16 pages) ,
- Quick manual (2 pages)
Table of Contents
Advertisement
DIR-842V2
AC1200 Wi-Fi Gigabit Router
User Manual
Configuring Wired WAN Connection
This configuration step is available for the Router and WISP Repeater modes.
You should configure your WAN connection in accordance with data provided by your
!
Internet service provider (ISP). Make sure that you have obtained all necessary information
prior to configuring your connection. Otherwise contact your ISP.
1. On the Internet connection type page, click the SCAN button (available only for the
Router mode) to automatically specify the connection type used by your ISP or manually
select the needed value from the Connection type list.
2. Specify the settings necessary for the connection of the selected type.
3.
If your ISP uses MAC address binding, select the Clone MAC address of your device
checkbox
(available only for the Router
4.
If the Internet access is provided via a VLAN channel, select the Use VLAN checkbox and
fill in the VLAN ID field
5.
Click the NEXT button to continue or click the BACK button to return to the previous page.
mode).
(available only for the Router
Page 54
Configuring via Web-based Interface
mode).
- Quick Links:
- Chapter 1. Introduction
- General Information
Hide quick links:
Advertisement
Table of Contents
