Chapter 4 Installation
Intercabling Connections
Table 4-26 EAS/EAS2 modular alarm connection pinouts
Alarm
code
225
RF #3
226
RF #3
227
RF #3
228
RF #3
229
RF #2
230
RF #2
231
RF #2
232
RF #2
233
RF #1
234
RF #1
235
RF #1
236
RF #1
237
CONTROL
238
CONTROL
239
CONTROL
240
CONTROL
Site Controller to Telephone Network T1/E1 Cabling
4-56
Connector
The local telephone company installs the T1/E1 line, which terminates in an
8-pin modular plug. This demarcation (demarc) point connects to the T1/E1
through a surge arrestor. Figure 4-22 shows the T1/E1 interface with the
system.
The surge arrestor must be adequately grounded as outlined in the Quality
Standards Fixed Network Equipment - Installation Manual (R56). The surge
arrestor usually mounts near the demarcation (demarc) point. The cable
connecting the surge arrestor to the Telco SmartJack should be locally
procured, or should be provided with the surge arrestor. The cable
connecting the Controller to the surge arrestor is locally procured.
Pins
1, 2
RFC 3 circuit breaker
3, 6
RFC 3 combiner/multicoupler amplifier
5, 8
RFC 3 combiner/multicoupler power supply
7, 4
RFC 3 tower top amplifier
1, 2
RFC 2 circuit breaker
3, 6
RFC 2 combiner/multicoupler amplifier
5, 8
RFC 2 combiner/multicoupler power supply
7, 4
RFC 2 tower top amplifier
1, 2
RFC 1 circuit breaker
3, 6
RFC 1 combiner/multicoupler amplifier
5, 8
RFC 1 combiner/multicoupler power supply
7, 4
RFC 1 tower top amplifier
1, 2
Control cabinet circuit breaker
3, 4
Output: RF relay Sector/Cell 1
5, 6
Output: RF relay Sector/Cell 2
7, 8
Output: RF relay Sector/Cell 3
Gen 3 Site Controller System Manual
EAS/EAS2 function
68P80801E30-A 5/1/2002