Replacing Engagement Roller Bearing Sleeves - Husqvarna K7000 Ring Workshop Manual
Hide thumbs
Also See for K7000 Ring:
- Operator's manual (128 pages) ,
- Workshop manual (24 pages) ,
- Operator's manual (92 pages)
Table of Contents
Advertisement
9
REPLACING ENGAGEMENT ROLLER BEARING SLEEVES
506 37 53-01
16
Dismantling
Tool
The special tool 506 37 53-01 is needed to replace the bearing sleeve.
Remove the water disc
The work is facilitated if the water disc is removed. Page 18 has a description
of how this is done.
Lubricate the tool
This is particularly important when the bearing sleeve is fitted for the
following reasons: When the bearing sleeve is screwed in with the tool, there is
a tendency for the bearing sleeve to rotate in the screw direction. Greaseing
the tool's sliding surfaces minimises this effect.
Removal is carried out in two steps
1. First fit the puller without the intermediate ring and press out the bearing
sleeve a few centimetres.
2. Supplement the puller with the intermediate ring and press out the bearing
sleeve completely.
Installation
Turn the lubricating ducts correctly!
Note that the lubrication ducts in the bearing sleeve have a different look on
the inlet and outlet side.
The large hole in the bearing sleeve is to face the grease nipple, while the
milled duct with the small hole is to face the outlet side.
Advertisement
Table of Contents
