Advertisement
OPERATION
3
•
Setup and measurement procedure is as follows:
a. Set the instrumentls INT BIAS switch on the front panel to the ±42V MAX
pos it i on.
b. Connect the l6080A directly to the UNKNOWN terminals of the instrument.
c. Perform internal or ex ternal error correction as described in SECTION
III of the instrumentls operation and service manual.
d. Insert the OUT into the test fixture.
4. MAINTENANCE
The internal wiring of the l6080A is shown in Figure 3 and an ex ploded view
-for parts identification
than
shown.
Maintenance
replacing
worn or damaged parts.
To order parts,
use the Hewlett-packard part numbers listed in Figure 4.
faulty part is located in an assembly that cannot be disassembled,
nex t higher assembly or return the whole device to the nearest Hewlett-Packard
Sales/Se�vice Office for repair or replacement.
in Figure 4.
-
consists
principally
Take special care when cleaning contacts.
Internal Wiring of l6080A
Figure 3.
-— 4 —-
Do not disassemble any further
of
cleaning
contacts
I I
I I
I I
..
. .
I I
I I
I I
I
and
If a
order
the
Advertisement
