Electrolux EWM09312 Service Manual page 64
Hide thumbs
Also See for EWM09312:
- Service manual (69 pages) ,
- Service manual (124 pages) ,
- Service manual (61 pages)
Table of Contents
Advertisement
EH3
The appliance remains in alarm status until the mains voltage returns to the correct values
!
or the appliance is switched off (programme selector set to "0"). Only the family of the
alarm is displayed and the diagnostics mode cannot be accessed. The complete alarm can
Is the supply line disturbed or the mains voltage
out of range?
Have the electrical system of the home
checked / repaired by the proper Body.
Technical Support - A.D.L.
EH3: Supply voltage too low
Supply voltage value higher than the one configured
only be read when the situation has normalised.
Y
E
S
!
Check that all the connectors are correctly inserted
Important
Replace the main circuit board and repeat the
diagnostic cycle to check for any further
NO
!
64/70
alarms.
If there are burns on the circuit board,
see page 68
EH3
!
599 74 23-12 Rev.00
Hide quick links:
Advertisement
Table of Contents
