Table of Contents
Advertisement
5. DIAGNOSTIC TEST OPERATION
5.
DIAGNOSTIC TEST OPERATION
This chapter describes the Diagnostic Test Program provided to check for proper operation of the POS I/O
devices of ST-B10.
5.1 Outline
As the ST-B10 diagnostic test program, Serviceman Diagnostic Test Program performed with a USB memory is
provided.
•
Serviceman Diagnostic Test Program
Linux-based diagnostic test program should be set up on the USB memory beforehand.
When this USB memory is inserted into the USB slot provided for the ST-B10 then the power is on, the
diagnostic test program starts up apart from the built-in disk.
In the Serviceman Diagnostic Test Program, tests concerning I/O devices connected to the ST-B10 can be
performed.
Prior to performing a diagnostic test with the USB memory, Linux-based diagnostic test program should be set
up on the USB memory.
•
When booting the diagnostic test program from a USB memory, refer to Section 4.4.2 and perform the BIOS
setting.
5.2 Serviceman Diagnostic Test Program Setup Procedure
This section describes procedures to set up the Linux-based diagnostic test program on the USB memory.
The USB memory with a capacity of 512 MB or more is satisfied.
For reference, operation-checked USB memories are shown below.
Operation-checked USB memory (for reference)
Maker
BUFFALO INC.
I-O DATA DEVICE INC.
ELECOM CO. LTD
A-DATA Technology Inc.
512 MB-or-more capacity is required.
NOTES:
1. ClipDrive is a registered trademark of BUFFALO INC..
2. ToteBag is a registered trademark of I-O DATA DEVICE INC..
3. my Flash is a registered trademark of A-DATA Technology Inc..
<< Preliminary version >>
Product Name
ClipDrive
ToteBag
MF-LU202GWH
my Flash
Capacity
512 MB
2 GB,
4 GB
2 GB
2 GB
1 GB
5- 1
EO18-12017
5.1 Outline
Remarks
Advertisement
Table of Contents
