Table of Contents
Advertisement
2 Safety information
Safety information
2
2.1
General safety instructions
Electric shock and danger to life due to other energy sources
Touching live components can result in death or serious injury.
• Only work on electrical equipment if you are appropriately qualified.
WARNING
• Always observe the country-specific safety rules for all work.
Generally, the following steps apply when establishing safety:
1. Prepare for disconnection. Notify all those who will be affected by the
procedure.
2. Isolate the drive system from the power supply and take measures to prevent
it being switched back on again.
3. Wait until the discharge time specified on the warning labels has elapsed.
4. Check that there is no voltage between any of the power connections, and
between any
of the power connections and the protective conductor connection.
5. Check that every auxiliary circuit is de-energized.
6. Ensure that the motors cannot move.
7. Identify all other dangerous energy sources, e.g. compressed air, hydraulic
systems or water. Switch the energy sources to a safe state.
8. Check that the correct drive system is completely locked. After you have
completed the work, restore the operational readiness by following the above
steps in the reverse order
Electric shock due to connection to an unsuitable power source
When equipment is connected to an unsuitable power source, exposed
components may carry a hazardous voltage that might result in serious injury or
WARNING
death.
• Only use power source that specified in this manual.
• Ensure that the power source wiring is correct.
RobIn eBox Installation Manual
Entry-ID: 109782794,
1.1.0,
04/2021
6
Advertisement
Table of Contents
