Table of Contents
Advertisement
3. Installation of outdoor unit
CAUTION
Use two or more people to lift and transport the product.
• Avoid personal injury.
Do not install the product where it will be exposed to sea wind (salt spray) directly.
• It may cause corrosion on the product. Corrosion, particularly on the condenser and evaporator fins, could cause product
malfunction or inefficient operation.
Keep level even when installing the product.
• To avoid vibration or noise.
Do not install the product where the noise or hot air from the outdoor unit could damage or disturb the neighbor-
hoods.
• It may cause a problem for your neighbors and hence dispute.
Always check for gas (refrigerant) leakage after installation or repair of product.
• Low refrigerant levels may cause failure of product.
Do not block the inlet or outlet of air flow.
• It may cause product failure.
Do not step on or put anyting on the product.
• There is risk of personal injury and failure of product.
Do not insert hands or other objects through the air inlet or outlet while the product is operating.
• There are sharp and moving parts that could cause personal injury.
Be cautious when unpacking and installing the product.
• Sharp edges could cause injury. Be especially careful of the case edges and the fins on the condenser and evaporator.
If the refrigerant gas leaks during the repair, do not touch the leaking refrigerant gas.
• The refrigernat gas can cause frostbite (cold burn).
Do not tilt the unit when removing or uninstalling it.
• The condensed water inside can cause spill and wet the furniture and the floor.
Do not mix air or gas other than the specified refrigerant used in the system.
• If air enters the refrigerant system, an excessively high pressure results, causing equipment damage or injury.
If the refrigerant gas leaks during the installation or operation ventilate the area immediately.
• Otherwise it can be harmfull for your health.
Do not expose your skin or kids or plants to the cool or hot air draft.
• This could harm to your health.
Use a firm stool or ladder when cleaning, maintaining or repairing the product at an height.
• Be careful and avoid personal injury.
Dismantling the unit , treatment of the refrigerant oil, oil and eventual parts should be done in accordance with
local and national standards.
39 _
Heat pump 50Hz/R410A
Hide quick links:
Advertisement
Table of Contents
