Table of Contents
Advertisement
Service Manual
Piston
1
Tubes and harness comes to the control unit
(5)
Label pad
The unit comes with 100x100mm or 110x150 Label pad without holes. This pad should be
customized depending on customer's label(s). The unit is factory adjusted, ready to work
(after label pad customization) and offers XYZ regulation
forward/backward
Air blow tube 'air-assist'
(11)
While printing keeps the label parallel to the label pad, the blowing point is positioned on the center of the
label around 1/3 of the label. When using EX4T1 the position is fixed on the label center. For EX4T2 label is
left side position.
When testing, when the printer is ready to print, there is a test button
than the label pad
(5)
and air assist
on the configuration menu accessible with the operation panel
Piston-Regulation
1
When working in 'contact' mode, pressure can be set moving up/down piston sensor
the flange that holds it.
Also the piston stoppers can be set up
smoothing the piston
(1)
2
(1)
Monoblock Piston / Guides
(2)
Sensor
adjusted to increase/decrease contact pressure of the label
pad
±4mm.
The piston has an adjustment
movement (400mm) as a security element to avoid hits on the
line o as a waiting point when using blow labeling.
Sensor harness, piston movement air tubes and vacuum/blow
tube moves inside a guided chain (4).
This guided chain and the special mounting piston as a
monoblock allow the P&A to be used on any position without
further adjustments.
(10)
(11)
are suitable. Also there are other configuration parameters available
2
(5)
stop.
Piston
Piston position sensors Down / Up
(2.2)
acts as a position/contact sensor, can be
(5)
against the product, moving the sensor up/down
inside a helical tape to prevent damages
(9)
(see user's manual).
(10)
Altough the unit is factory adjusted, the label
pad
(10)
Horizontal
air assist orientation adjust over label path
we can adapt the unit to any condition.
Also time parameters can me modified using
operation panel (7).
depending on the speed of movement to act before/after
8
(7)
(3)
to limit the maximum
(8).
(6)
up/down and
to print & apply one label and check
can be adjusted over the label exit on
(3.1)
and Vertical (3.2); also with the
(2)
loosening/tightening
(4)
- Quick Links:
- Product Description
- Operation Panel
Hide quick links:
Advertisement
Table of Contents
