Table of Contents
Advertisement
ACER Being Communication Inc.
After click "Flash image" , pls wait for a moment until the upload complete, then come to the
interface of "Flash Firmware-Verify", as below:
Note: When file is finished uploading, wait and check to make sure the Checksum is as
same as that of md5 file(which will be sent to customer together with the bin format file), if
it's the same, pls click PROCEED button. If the Checksum is not as same as that of md5
file, it's possible that the upload file damages. You should click CANCEL button to re-
upload, because the damaged file can make gateway to be brick. As below:
Note: After click PROCEED button, it's flashing the firmware, pls make sure the power
supply be stable, and wait for 3~5 minutes until it finishes.
After finishing flash firmware, there is no need to enter the Web page, the gateway will enable
by default.
FAQ
1. Gateway will not work after a power failure
When there is a power failure, the log on the TF card is damaged, after restart gateway, it'll do
self-check to automatically repair log, if TF card data quantity is large, it'll take a long time to
repair, in the process of repairing, the gateway is not working.
Solution: enter the configuration interface of gateway (192.168.3.1) , gateway login, select
"Network/LoRa GW/Status", click "CLEAR THE LOG OF TF CARD", as below:
36
Advertisement
Table of Contents
