Haier AW09EH2VHD Service Manual page 55

Ductless split heat pump
Table of Contents

Advertisement

Ductless Troubleshooting
Step 3
Reconnect the wiring to the IPM at the conclusion of the
test.
NOTE: Resistance readings shown in this section are for
reference only
Model
Winding resistance
09K
12K
18K
Checking the Base Pan Heater
The resistance across the heater should be 100 to 500 ohms.
reads open or shorted.
Checking Indoor Unit Components
Testing of the following components requires the use of an
ohmmeter and k-type temperature probe.
NOTE: When using the test probes, probe the back or side
contacts of the plug to obtain the reading. Do not try to
probe the connector end of the plug, as this may damage the
contacts.
Checking the Indoor Unit Sensors
NOTE: Use respective temperature / sensor chart for sensor
type being tested.
Coil sensor
Ambient sensor
Step 1
Disconnect the sensor from the PCB for this test. Failure to
do so may provide inaccurate readings.
Step 2
Determine the temperature of the sensor being tested.
Haier Ductless Technical Support Phone: 866.814.3633 (option 3) Email: ductlesshelp@geappliances.com Online: www.HaierDuctlessHelp.com
ter
ERROR CODES and Troubleshooting
Step 3
Check the resistance value of the sensor.
Step 4
Referring to the temperature / resistance table for the sensor
being checked, verify the resistance value corresponds to the
temperature checked in step 2.
Replace the sensor if the reading is open, shorted, or outside
Step 5
Re-seat the plug on the PCB at the conclusion of the test.
Checking the Up/Down Stepper Motor
Step 1
Disconnect the Up/Down Stepper Motor plug PCB for the test.
Failure to do so may provide inaccurate readings.
Step 2
Refer to the chart shown below for plug pin combinations and
resistance values.
Red
Orange
Yellow
Red
296.5Ohm 295.5 Ohm 296.3 Ohm
Orange
594.5 Ohm 595.5 Ohm 594.5 Ohm
Yellow
Pink
Blue
Step 3
Re-seat the plug on the connector at the conclusion of the
test.
C
h
e
k c
n i
g
h t
e
Left/Right Stepper Motor
Step 1
Disconnect the Motor plug from the PCB for this test. Failure
to do so may provide inaccurate readings.
Blue
Pink
296.1 Ohm
594.3 Ohm 594.5 Ohm
594.3 Ohm
P
AGE 55
Rev. 04-20

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aw12eh2vhdAw18eh2vhd1u09eh2vhd1u12eh2vhd1u18eh2vhd

Table of Contents