Table of Contents
Advertisement
1.12.3
Correcting Error Conditions
As a general rule, if an error message says "Press F1 to continue," it is
caused by a configuration problem, which can be easily corrected. An
equipment malfunction is more likely to cause a fatal error, i.e., an error that
causes complete system failure.
Here are some corrective measures for error conditions:
1.
Run Setup. You must know the correct configuration values for your
system before you enter Setup, which is why you should write them
down when the system is correctly configured. An incorrect
configuration is a major cause of power-on error messages, especially
for a new system.
2.
Remove the system cover, following the directions in the housing
installation manual. Check that the jumpers on the system board and
any expansion boards are set correctly.
3.
If you cannot access a new disk, it may be because your disk is not
properly formatted. Format the disk first using the FDISK and
FORMAT commands.
4.
Check that all connectors and boards are secure.
If you go through these steps and still receive an error message, the cause
may be an equipment malfunction.
If you are sure that your configuration values are correct and your battery is
in good condition, the problem may lie in a damaged or defective chip.
In either case, contact an authorized service center for assistance.
System Board
1-31
Advertisement
Table of Contents
