Toshiba e-STUDIO2010AC Imaging Manual page 133
Hide thumbs
Also See for e-STUDIO2010AC:
- Operator's manual (32 pages) ,
- Management manual (32 pages) ,
- User manual (20 pages)
Table of Contents
Advertisement
(2) Select [05 ADJUSTMENT MODE]. Change the values for codes [7023] to [7026] to adjust the
reproducibility of the background when using the DF.
Color mode
Full color
for RADF / front side for
DSDF
Black
for RADF / front side for
DSDF
Full color
for back side for DSDF
Black
for back side for DSDF
• The DSDF is available only for e-STUDIO2515AC/3015AC/3515AC/4515AC/5015AC.
• Set the value in increments of approximately 20, while checking the copy image until the optimum
value is obtained.
• Note that the adjustment results are also reflected to the scanning function.
Caution after the adjustment
Correctly adjusting the installation heights of the MFP and the DF is a prerequisite to perform this
adjustment. Therefore, perform all the necessary adjustments. Only if further adjustment is still desired for
the reproducibility of background, should this adjustment be performed.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Original
[05] code Recommended value
mode
ALL
05-7026
Set a value larger than
128 to increase the
ALL
05-7025
background density.
Set a value smaller
ALL
05-7024
than 128 to decrease
the background density.
ALL
05-7023
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-79
2.Copier-specific Adjustments
Acceptable
Default
value range
0 to 255
128
Hide quick links:
Advertisement
Table of Contents
