Table of Contents
Advertisement
MEX-GS610BE/GS610BT/N6050BT
2. DIAGRAMS
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
• X : Parts extracted from the component side.
• Y : Parts extracted from the conductor side.
•
: Internal component.
f
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen
(Conductor Side)
from the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side)
the parts face are indicated.
• Indication of transistor.
C
Q
These are omitted.
B
E
Note: When the complete MAIN board is replaced, it is nec-
essary to replace knob (VOL) (SV) assy simultane-
ously. Also, the destination setting, Bluetooth operation
check and Bluetooth information writing is necessary.
Refer to "DESTINATION SETTING METHOD" on
page 4, "BLUETOOTH FUNCTION CHECKING
METHOD USING A CELLULAR PHONE" on page
7 and "BLUETOOTH INFORMATION WRITING
METHOD" on page 8 on original service manual.
2
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and 1/4 W or less unless otherwise
specifi ed.
•
: Internal component.
f
• C : Panel designation.
Note:
The components identi-
fi ed by mark 0 or dotted
line with mark 0 are criti-
cal for safety.
Replace only with part
number specifi ed.
• A : B+ Line.
• Power voltages is dc 14.4V and fed with regulated dc
power supply from ACC and BATT cords.
• Voltages are dc with respect to ground under no-signal
(detuned) conditions.
no mark : TUNER (FM)
(
) : CD PLAY
• Voltages are taken with VOM (Input impedance 10 M).
Voltage variations may be noted due to normal production
tolerances.
• Signal path.
: AUDIO
F
: TUNER
f
: SIRIUS/XM
h
: CD PLAY
J
: USB
d
: AUX
E
: Bluetooth
a
: MIC
N
Note: When the complete MAIN board is replaced, it is nec-
essary to replace knob (VOL) (SV) assy simultane-
ously. Also, the destination setting, Bluetooth operation
check and Bluetooth information writing is necessary.
Refer to "DESTINATION SETTING METHOD" on
page 4, "BLUETOOTH FUNCTION CHECKING
METHOD USING A CELLULAR PHONE" on page
7 and "BLUETOOTH INFORMATION WRITING
METHOD" on page 8 on original service manual.
Note:
Les composants identifi és
par une marque 0 sont
critiques pour la sécurité.
Ne les remplacer que par
une pièce portant le nu-
méro spécifi é.
Hide quick links:
Advertisement
Table of Contents
