Table of Contents
Advertisement
When enabled, LCR is invoked by dialling an access code; this code is usually 9. LCR is enabled in
this MMC on a trunk by trunk base.
NX-308 provides a "fake" dial tone to the station user as a signal to begin dialling.
The digits are dialled but are not immediately sent to the C.O.; they are stored in a buffer for analysis
by LCR Digit Table. System toll restriction checks each digit as it is dialled to determine if the call is
allowed for the dialling station.
Action
1.
Press CONF key and 900
2.
Press MSG key to select line
3.
Input 1 (Enable) or 0 (Disable)
4.
Press CONF key to store and exit
Default data : Disabled
MMC901 LCR Digit Table
The LCR Digit Table contains all numerical digits for the completion of outgoing call placement. This
table works in conjunction with LCR Route Table, and LCR Modify Digits Table. There is a
maximum of 250 entries with a digit string length of 10 numerical digits. This system will
automatically maintain entered digit strings in numerical order.
By default, the system routes dialled digits not entered in LCR Digit Table to route 01 (i.e. 132,
Mercury easy access).
Action
1.
Press CONF key and 901
2.
Dial LCR entry
OR
Press MSG key to select entry
(LCR entry range: 000 - 250)
3.
Press ALM key to input digits string up to 10 digits
4.
Press ALM key to input digits length
5.
Enter digits length (00 - 10)
6.
Press ALM key to input route selection
7.
Enter route selection (00 - 15)
8.
Press CONF key to store and exit
(If you want to delete any item, press HOLD key in any state.)
Default data:
LCR digit
Dialled digit
Display
ENABLE LCR
LINE1:DISABLED
ENABLED
Display
LCR DIGIT (000)
LCR DIGIT (001)
DIGIT:
LENGTH:
ROUTE:
Length
Route
45
Hide quick links:
Advertisement
Table of Contents
