Table of Contents
Advertisement
Available languages
Available languages
Install Doors
F3b
F3b
Phillips-head screw (12)
F9
Door catch (1)
IMPORTANT: The door with the lock assembly (P7) should be
installed on the right-hand side of the cabinet.
1. Align the holes in the right-hand door hinge with the holes in the
right-hand cabinet side.
2. Using six Phillips-head screws, starting with the top hole, fasten
the door (P7) to the cabinet side. Hand-tighten the screws.
3. Insert the door catch (F9) into the rectangular opening, above the
lock, as shown.
P2
P5
P1
P5
A
P5
P3
A. Phillips-head screws
4. Repeat steps 1 and 2 to attach the left-hand door (P6).
5. Align the doors and fully tighten the screws.
F9
P7
F9
Complete Assembly
1. Make sure there is a bolt or screw in each hole of the cabinet
frame.
2. Move the cabinet to its final location.
3. Place a level on an inside shelf, and if necessary, level the
cabinet by adjusting the height of the leveling legs. Turn to the
left to raise or to the right to lower the leveling leg.
4. If the doors are not aligned, loosen all the screws attaching the
door hinge to the cabinet.
5. Adjust door to the desired height, and fully tighten the screws.
ACCESSORIES
To order accessories, call 1-866-342-4089 and ask for the accessory
part number listed below or contact your authorized Gladiator
GarageWorks dealer. In Canada, call 1-800-807-6777.
Mounting Bracket Kit - Allows the cabinet to be mounted on
®
Gladiator
Garageworks GearWall
Order Part # GABK362PSS
®
®
®
panels or GearTrack
channels.
5
Advertisement
Table of Contents
