Toro 2024 Directional Drill Software Manual page 15

Hide thumbs Also See for 2024 Directional Drill:

Cam Arm I/O Screen

To access this screen push button 3 on the I/O screen.

Use this screen to adjust the cam calibration options.

Push the up and down buttons to select the load

position and the pipe-row position.

The voltage on the bottom indicates the cam raw

sensor voltage. The voltages range from 1.0 to 4.0 V.

Any voltage higher or lower indicates either sensor

failure or incorrect calibration.

The other voltages are calibrated voltages.

Push button 3 to toggle the calibration on and off.

Push the OK button 3 times on the desired row to

save the calibration.

Figure 56

Auxiliary I/O Screen

To access this screen push button 5 on the I/O screen.

All icons change from black to green when you

operate the associated functions.

g204520

1. Raise/Lower elevator

2. Breakout wrench

3. Vise

4. Gripper

The breakout wrench icon will show arrows above the

icon to indicate when the rotating wrench is open or

closed.

Figure 57

5. Arm extension/retract

sensor

6. Rotate pipe cam

7. TJC grease

g207493

23800 23800a 23800c 23800te 23800w