Page 1
Owner's Record The model number and serial number are on the back of your TV. Record these numbers in the spaces below. Refer to these numbers whenever you communicate with your Toshiba dealer about this TV. Model number: Serial number:...
Important Information WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. The lightning symbol in the triangle tells you that the voltage inside this product may be strong enough to cause an electric shock.
Introduction ... 4 Welcome to Toshiba ... 4 Exploring your new TV ... 4 Connecting your TV ... 5 Connecting a VCR ... 5 Connecting a cable converter box ... 6 Connecting a cable converter box and a VCR ... 6 Connecting a DVD/satellite receiver and a VCR ...
Congratulations! You have purchased one of the finest projection TVs on the market. The goal of this manual is to guide you through setting up and operating your Toshiba TV as quickly as possible. Before you start reading, check your model number by looking at the rear of the TV.
Connecting your TV If you have not connected electronic equipment before, or you have been frustrated in the past, you may wish to read this section. (Cables are not supplied.) • A coaxial cable is the standard cable that comes in from your antenna or cable converter box.
Connecting a cable converter box This connection allows you to watch cable and premium channels. To use the TV’s features, select ANT-1. To view premium channels, select ANT-2 and tune the TV to channel 3 or 4 (whichever channel is vacant in your area), then use the converter box to change channels.
DVD or TV programs. You can record from one source and watch a program from another source. Your TV is capable of using ColorStream (component video). Connecting your TV to a ColorStream compatible DVD, such as a Toshiba DVD, can greatly enhance picture quality and performance. You will need: •...
Stereo VCR IN from ANT OUT to TV From Antenna CH 3 CH 4 S-VIDEO VIDEO AUDIO S-VIDEO COLOR STREAM DVD Player With ColorStream Connecting two VCRs This connection allows you to record (dub/edit) from one VCR to another VCR while watching a video program. You also will be able to record from one TV channel while watching another channel.
Connecting a camcorder This connection allows you to watch video materials recorded on a camcorder. You will need: • one pair of audio cables • one video cable VIDEO AUDIO Connecting an audio system This connection allows you to use an audio amplifier to adjust the audio level.
Connecting an A/V receiver If you have a system with Dolby Pro Logic* surround sound, using the TV speakers as center channel speakers will add to the realism of the sound. You will need: • one pair of audio cables •...
The remote control provided with your TV can operate most VCRs and cable TV converters as well. It is already programmed to operate Toshiba VCRs; however, you will have to program it if you want to operate non-Toshiba equipment (see “Programming the remote control for use with a VCR or a cable TV converter”...
Programming the remote control for use with a VCR or a cable TV converter The remote control provided with your TV is preprogrammed to operate Toshiba brand VCRs. You can program your TV remote control to operate other brands of VCRs and cable TV converters as well.
Learning about the remote control displays the AUDIO menu (page 37) turns the TV on and off POWER controls the TV controls the cable TV converter (page 12) CABLE controls the VCR (page 11) displays the CUSTOM menu to set the sleep timer (page 35) TIMER allow direct access to channels (page 19) Channel Numbers [0-9,100]...
Setting up your TV Learning about the menu system After you have installed the batteries and programmed the remote control, you will need to set some preferences on the TV using the menu. You can access the menu using the buttons on your TV or remote control.
Changing the on-screen display language You can choose from three different languages (English, French and Spanish) for the on-screen displays. Adjustment menus and messages will appear in the language of your choice. To select a language: 1. Press MENU, then press x or • until the SET UP menu appears. 2.
Adding channels to the TV’s memory When you press Channel y or z, your TV will stop only on channels that are stored in the channel memory. Note: To tune the TV to a channel not programmed in the channel memory, use the Channel Number buttons on the remote control.
Adding and erasing channels manually After you have programmed the channels automatically, you can manually add or erase specific channels. To add or erase channels: 1. Select the channel you want to add or erase. If you are adding a channel, you must use the Channel Number buttons to select the channel.
Page 20
3. Press x or • to display the center CONVERGENCE menu. 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 B L U E ENTER TO SELECT COLOR...
Using the TV’s features Adjusting the channel settings Switching between two channels You can switch between two channels without entering an actual channel number each time. To switch between two channels: 1. Select the first channel you want to view. 2.
To clear your favorite channels: 1. Press MENU, then press x or • until the CUSTOM menu appears. 2. Press y or z to highlight FAVORITE CH2 for example. 3. Press x or • to display the FAVORITE CH2 menu. 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 CUSTOM T I MER...
Page 23
6. Assign the label to the channel. Press x or • to enter a character in the first space. Press the button repeatedly until the character you want appears on the screen. Press ENTER. 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 CUSTOM T I MER FAVOR I...
Watching picture-in-picture (PIP) The picture-in-picture (PIP) feature allows you to watch two pictures at the same time. The smaller picture can come from a TV broadcast or an external source, such as a VCR. To display a TV broadcast as a small picture: 1.
Switching the main and small pictures Press SWAP while you are using the PIP feature to switch the main and small pictures. The main and small pictures will switch each time you press the SWAP button. Changing the position of the small picture Press LOCATE repeatedly while you are watching a small picture.
Using the LOCKS menu The LOCKS menu includes the V-CHIP, CH LOCK, VIDEO LOCK, and NEW PIN CODE functions. You can use these functions after entering the correct PIN code. Entering the PIN code 1. Press MENU, then press x or • until the LOCKS menu appears. 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 LOCKS V CH I P...
Using the V-CHIP menu Some TV programs and movies include signals that classify the content of the program (violence, sex, dialog, language). The V-CHIP control feature in this TV detects the signals and blocks the programs according to your selections. To use this feature, perform the following setup.
MPAA RATING (Independent rating system for movies) 1. From the LOCKS menu, select MPAA RATING. 2. Press x or • to display the MPAA RATING menu, then press z or y to highlight MPAA RATING. 3. Press x or • to display the MPAA RATING menu. 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 LOCKS MPAA RAT I NG...
Unlocking programs temporarily 1. If you try to watch a TV program that exceeds the rating limits you set, the TV will enter into the program lock mode. TH I S PROGRAM HAS BEEN BLOCKED ! – EXCEEDS SET L I I TS PUSH MUTE TO ENTER CABLE...
To unlock channels: 1. From the LOCKS menu, select CH LOCK. 2. Press x or • to display the CH LOCK menu. 3. Press y or z to highlight CLEAR. 4. Press x or • until “0” replaces the channel numbers you have locked.
Adjusting the picture Selecting the picture mode You can select your desired picture type from four picture modes— sports, standard, movie, and preference—as described in the following table: Mode Picture Quality sports bright and dynamic picture (factory setting) standard standard picture setting movie movie-like picture setting preference...
Saving new preference You can save the PICTURE qualities (contrast, brightness, color, tint, and sharpness) you have adjusted in the picture preference mode. To save your new preferences: 1. Press MENU, then press x or • until the PICTURE menu appears.
Selecting the color temperature You can change the quality of the picture by selecting from three preset color temperatures: cool, medium, and warm. Mode Picture Quality cool blueish medium neutral warm reddish To select the color temperature: 1. Press MENU, then press x or • until the PICTURE menu appears.
Watching video input You can use the TV/VIDEO button on the remote control or TV to view a signal coming from other devices connected to your TV, such as VCRs or video disc players. Select VIDEO 1, VIDEO 2, VIDEO 3, or ColorStream, depending on which input jacks are used for connecting the devices.
Using the closed caption feature The Closed Caption feature has two options: • Captions—An on-screen display of the dialogue, narration, and sound effects of programs and videos that are closed-captioned (usually identified in your local TV listing as “CC”). • Text—An on-screen display of information not related to the program, such as weather or stock reports (if available in your area).
Setting the timer (sleep timer) You can set the sleep timer so the TV turns off automatically. To set the sleep timer: 1. Press TIMER (or MENU then yz) to display the CUSTOM menu. TIMER will be highlighted. 2. After the number position starts to blink, press TIMER repeatedly to enter the length of time until the TV turns off automatically (in 10-minute increments to a maximum of 180).
Adjusting the sound Muting the sound Press MUTE to temporarily turn off the sound. While the sound is off, the screen will display the word MUTE in the lower right corner. To restore the sound, press MUTE again. When you press the MUTE button, the Closed Caption feature is automatically activated.
Using the surround sound feature The surround sound feature expands the audio listening field wider and deeper to create exceptional sound quality from the TV’s speakers. The feature uses stereo signals from a TV broadcast or video input. To turn on the surround sound feature: 1.
Adjusting the sound quality You can change the quality of your TV’s sound by adjusting the bass, treble, and balance. To adjust the sound quality: 1. Press MENU, then press x or • until the AUDIO menu appears. 2. Press y or z to highlight the item you want to adjust. 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 AUD O STEREO...
Using the Sub-Bass System (SBS) The Sub-Bass System allows you to enhance bass performance, even when the volume is low. To turn on the Sub-Bass System: 1. Press MENU, then press x or • until the AUDIO menu appears. 2. Press y or z to highlight SBS. 3.
Selecting the Audio OUT sound This feature allows you to select the sound source (MAIN or PIP) that is output from the Audio OUT jacks. This is useful when amplifying or recording the PIP sound with external equipment while hearing the sound of the main picture through the built-in speakers.
Viewing the demonstration mode When you press DEMO on the TV, the TV automatically displays a variety of its on-screen menus and special features. This function is provided for demonstration purposes only. To stop the demonstration mode: Press DEMO again. Understanding the auto power off feature The TV will automatically turn itself off after approximately 15 minutes if it is tuned to a vacant channel or a station that completes...
Appendix Specifications Television System NTSC standard Channel Coverage VHF: 2 through 13 UHF: 14 through 69 Cable TV: Mid band (A-8 through A-1, A through I) Power Source 120 V AC, 60 Hz Power Consumption 137 W (average) Audio Power 14 W + 14 W Speaker Type Two 6-1/4 inches (16 cm) round...
Troubleshooting Before calling a service technician, please check the following table for a possible cause of the problem and some solutions. Problem TV will not turn on No picture, no sound No sound, picture OK Poor sound, picture OK Poor picture, sound OK Poor reception of broadcast channels Cannot receive above channel 13 Black box appears on the screen...
ATTENTION CANADIAN CONSUMERS: Canadian consumers are requested to complete the special Canadian “Warranty Registration Form” enclosed, and forward this completed form with a copy of bill of sale to TOSHIBA OF CANADA to “Register and Validate” their warranty. Products purchased in the U.S.A. and used in Canada are not covered by these warranties.
Index A/V receiver connection ... 10 ANT 1/2 ... 17 Antenna cables ... 5 Audio cables ... 5 AUDIO OUT sound, selecting ... 41 Audio system connection ... 9 Auto power off ... 42 Back of the TV ... 4 BACKGROUND selection ...41 Cable box connection ...
Page 47
MONTREAL: 1643, NORTH SERVICE RD., TRANS-CANADA HIGHWAY, DORVAL QUEBEC, H9P 1J1, CANADA TEL: (514) 856-4100 VANCOUVER: 22171 FRASERWOOD WAY, RICHMOND, B.C. V6W 1J5, CANADA TEL: (604) 303-2500 MANUFACTURED BY ColorStream is a registered trademark of Toshiba America Consumer Products, Inc. PRINTED IN USA (00-11)B 23563971A...