Figure 48
1. Horn switch
Installing the Light Switch
1. Remove the existing 8-socket connector from the old
light switch
(Figure
Figure 49
1. Control-panel cover
2. Old light switch
2. Remove the old light switch from the control-panel
cover
(Figure
49).
Note: You no longer need the old light switch.
3. Insert the 1 socket connector of the kit harness into
the slot number 1 of the 8-socket connector of the
main harness
(Figure
Note: Insert the blade into slot number 1 on the
8-socket connector to ensure that the new light switch
works properly.
2. 2-pin connector
49).
3. 8-socket connector
50).
1. Socket connector
4. Install the light-switch decal onto the control-panel
cover, centered over the light switch opening, with the
words
SONIC BOOM
(Figure
51).
1. Control-panel cover
2. Light-switch decal
5. Insert the plain 3-position switch (without the
hazard symbol) into the light switch opening of the
control-panel cover with the tail of the switch rearward
(Figure
51).
6. Connect the 8-socket connect of the machine harness
to the 3-position switch
20
Figure 50
2. Light-switch connector
(slot number 1)
toward the back of the machine
Figure 51
3. 3-position switch (plain)
4. Back of the machine
(Figure
52).