Siemens SINAMICS S120 Instruction For Installation In Cabinets For Marine Drive Applications page 9

Power-units / chassis liquid-cooled

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Fig. 2: Cabinet setup with mounting plate set toward the front

Cabinet:

Installation of Motor Modules, Active Line Modules and Diode Line Modules

The Motor Modules, Active Line Modules and Diode Line Modules shhall be mounted

to the backside of a mounting plate, in compliance with their fixing holes. The

mounting plate can be mounted to the backside of the cabinet, as shown in Fig. 1. If

the arrangement of the mounting plate is not possible at the backside of the cabinet,

special attention has to be paid on a stable installation of the mounting plate (see Fig.

2).

Underneath the power units mounting brackets have to be fixed for the support of the

power units.

Additionally a fixation in the front section of the power units is required. For that, in

case of Motor Modules, Active Line Modules and Diode Line Modules, the holes of the

lower mounting brackets and the thread hole of the eyebolt can be used (eyebolt is

mounted for transportation only).

Instruction for installation of the liquid-cooled chassis of Sinamics S120 power units into cabinets for marine drive applications,

12/2016, 4BS0808-003

Reinforcement of the cabinet in the bottom area

Stiffening frame for the cabinet door

Per each side minimum three struts in direction of the cabinet depth

Mechanical design

Table of Contents